3D-Printed Monitor Stand with drawers for Asus VS247HR 23,6inch display (Stackable, Customizable)
The display's stand is too low for my liking. I used to use my PowerBook 180c as a riser - but that felt just wrong. The poor P'Book. So I created this stand, it features:
- variable height
I adjusted the model to fit on my printing bed (cut the back side off). You can re-enable printing the whole thing in the .scad.
Just print it. 10% infill or more and support (for the stand, not the drawer) are recommended. PLA does fine.