3D-Printed Shower Head Holder: Difference between revisions
Jump to navigation
Jump to search
| Line 1: | Line 1: | ||
=== The Mission === | === The Mission === | ||
I wanted to hang the shower head as high as possible. Again, without drilling. | I wanted to hang the shower head as high as possible. Again, without drilling. I used a https://www.thingiverse.com/thing:10407 as a basis. | ||
=== The Result === | === The Result === | ||
Revision as of 12:07, 18 November 2018
The Mission
I wanted to hang the shower head as high as possible. Again, without drilling. I used a https://www.thingiverse.com/thing:10407 as a basis.
The Result
Instructions
Just print it. 25% infill or more recommended. PLA does fine. Use ABS for extra strength. If you want to waterproof it (structure might soak up water), use acetone or some colour).
The Downloads
Links
- List of 3D-Designs
- Thingiverse: https://www.thingiverse.com/XXXX