Use Raspberry Pi for 3D-Printing: Difference between revisions
Jump to navigation
Jump to search
Line 9: | Line 9: | ||
=== Using Repetier Host === | === Using Repetier Host === | ||
I found http://www.3deee.ch/?p=279 | I found http://www.3deee.ch/?p=279 and http://help.printrbot.com/Guide/Installing+Repetier-Host+for+Linux/75 | ||
---- | ---- |
Revision as of 22:05, 31 March 2015
Prerequisites
Make sure, you set up your Pi properly, install all updates and connect it the internet[1] by editing /etc/wpa_supplicant/wpa_supplicant.conf, apt-get update, apt-get upgrade
Using OctoPrint
I found this regarding OctoPrint:
https://github.com/foosel/OctoPrint/wiki/Setup-on-a-Raspberry-Pi-running-Raspbian
Using Repetier Host
I found http://www.3deee.ch/?p=279 and http://help.printrbot.com/Guide/Installing+Repetier-Host+for+Linux/75
- Footnotes: