3D-Printed Lights mounting on bonnet: Difference between revisions
Jump to navigation
Jump to search
(Created page with "=== The Mission === After my son broke the lights on my bronco I needed a replacement. Working, if possible... === The Result === Image:3D-Printed Lights mounting on bonnet...") |
|||
(One intermediate revision by the same user not shown) | |||
Line 16: | Line 16: | ||
* PLA does fine | * PLA does fine | ||
* Support might be a good idea | * Support might be a good idea | ||
* Use some scrap lexan to cut lenses. You can also print the lenses, or at least use printed lenses as mask for cutting out the lexan lenses. | |||
=== The Downloads === | === The Downloads === | ||
Line 24: | Line 25: | ||
* [[List of 3D-Designs]] | * [[List of 3D-Designs]] | ||
* Thingiverse | * Thingiverse | ||
** This design: https://www.thingiverse.com/thing: | ** This design: https://www.thingiverse.com/thing:3487945 | ||
[[Category:3D Printing]] | [[Category:3D Printing]] |
Latest revision as of 00:10, 13 March 2019
The Mission
After my son broke the lights on my bronco I needed a replacement. Working, if possible...
The Result
Instructions
- 100% infill
- PLA does fine
- Support might be a good idea
- Use some scrap lexan to cut lenses. You can also print the lenses, or at least use printed lenses as mask for cutting out the lexan lenses.
The Downloads
Links
- List of 3D-Designs
- Thingiverse
- This design: https://www.thingiverse.com/thing:3487945