3D-Printed Monitor Stand with drawers for Asus VS247HR 23,6inch display (Stackable, Customizable): Difference between revisions

From Wurst-Wasser.net
Jump to navigation Jump to search
 
Line 1: Line 1:
=== The Mission ===
=== The Mission ===
The display's stand is too low for my liking. I used to use my PowerBook 180c as a riser - but that felt just wrong. The poor P'Book. So I created this stand, it features:
The display's stand is too low for my liking. I used to use my PowerBook 180c as a riser - but that felt just wrong. The poor P'Book. So I created this stand, it features:
- variable height
* variable height
- stackable
* stackable
- drawer
* drawer
 
I adjusted the model to fit on my printing bed (cut the back side off). You can re-enable printing the whole thing in the .scad.


=== The Result ===
=== The Result ===

Latest revision as of 13:57, 20 December 2018

The Mission

The display's stand is too low for my liking. I used to use my PowerBook 180c as a riser - but that felt just wrong. The poor P'Book. So I created this stand, it features:

  • variable height
  • stackable
  • drawer

I adjusted the model to fit on my printing bed (cut the back side off). You can re-enable printing the whole thing in the .scad.

The Result

3D-Printed Monitor Stand with drawers for Asus VS247HR 01.jpg 3D-Printed Monitor Stand with drawers for Asus VS247HR 02.jpg 3D-Printed Monitor Stand with drawers for Asus VS247HR 03.jpg 3D-Printed Monitor Stand with drawers for Asus VS247HR 04.jpg 3D-Printed Monitor Stand with drawers for Asus VS247HR 05.jpg

Instructions

Just print it. 10% infill or more and support (for the stand, not the drawer) are recommended. PLA does fine.

The Downloads


Links