3D-Printed Monitor Stand with drawers for Asus VS247HR 23,6inch display (Stackable, Customizable): Difference between revisions
Jump to navigation
Jump to search
(Created page with "=== The Mission === The display's stand is too low for my liking. I used to use my PowerBook 180c as a riser - but that felt just wrong. The poor P'Book. So I created this sta...") |
|||
| (2 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
=== The Mission === | === The Mission === | ||
The display's stand is too low for my liking. I used to use my PowerBook 180c as a riser - but that felt just wrong. The poor P'Book. So I created this stand, it features: | The display's stand is too low for my liking. I used to use my PowerBook 180c as a riser - but that felt just wrong. The poor P'Book. So I created this stand, it features: | ||
* variable height | |||
* stackable | |||
- | * drawer | ||
I adjusted the model to fit on my printing bed (cut the back side off). You can re-enable printing the whole thing in the .scad. | |||
=== The Result === | === The Result === | ||
| Line 10: | Line 12: | ||
[[Image:3D-Printed Monitor Stand with drawers for Asus VS247HR 03.jpg|666px]] | [[Image:3D-Printed Monitor Stand with drawers for Asus VS247HR 03.jpg|666px]] | ||
[[Image:3D-Printed Monitor Stand with drawers for Asus VS247HR 04.jpg|666px]] | [[Image:3D-Printed Monitor Stand with drawers for Asus VS247HR 04.jpg|666px]] | ||
[[Image:3D-Printed Monitor Stand with drawers for Asus VS247HR 05.jpg|666px]] | |||
=== Instructions === | === Instructions === | ||
| Line 15: | Line 18: | ||
=== The Downloads === | === The Downloads === | ||
* [[file: | * [[file:Asus Monitor Stand v3.zip]] | ||
---- | ---- | ||
Latest revision as of 14:57, 20 December 2018
The Mission
The display's stand is too low for my liking. I used to use my PowerBook 180c as a riser - but that felt just wrong. The poor P'Book. So I created this stand, it features:
- variable height
- stackable
- drawer
I adjusted the model to fit on my printing bed (cut the back side off). You can re-enable printing the whole thing in the .scad.
The Result
Instructions
Just print it. 10% infill or more and support (for the stand, not the drawer) are recommended. PLA does fine.
The Downloads
Links