3D-Printed Monitor Stand with drawers for Asus VS247HR 23,6inch display (Stackable, Customizable): Difference between revisions
Jump to navigation
Jump to search
Line 1: | Line 1: | ||
=== The Mission === | === The Mission === | ||
The display's stand is too low for my liking. I used to use my PowerBook 180c as a riser - but that felt just wrong. The poor P'Book. So I created this stand, it features: | The display's stand is too low for my liking. I used to use my PowerBook 180c as a riser - but that felt just wrong. The poor P'Book. So I created this stand, it features: | ||
* variable height | |||
* stackable | |||
- | * drawer | ||
I adjusted the model to fit on my printing bed (cut the back side off). You can re-enable printing the whole thing in the .scad. | |||
=== The Result === | === The Result === |
Latest revision as of 14:57, 20 December 2018
The Mission
The display's stand is too low for my liking. I used to use my PowerBook 180c as a riser - but that felt just wrong. The poor P'Book. So I created this stand, it features:
- variable height
- stackable
- drawer
I adjusted the model to fit on my printing bed (cut the back side off). You can re-enable printing the whole thing in the .scad.
The Result
Instructions
Just print it. 10% infill or more and support (for the stand, not the drawer) are recommended. PLA does fine.
The Downloads
Links